Category Archives: Jeep

News about Jeep automobile manufacturer. News about Jeep recalls, technical service bulletins (TSB), and problems regarding Jeep vehicles.

2021 Jeep Cherokee Transmission Leak

Posted on by

transmission hose leakIn March 2021, Chrysler / FCA USA Vehicle Safety and Regulatory Compliance (VSRC) organization received information about a potential trend in engine fires in certain Jeep Cherokee vehicles equipped with automatic transmissions.

The investigation found the problem to be that certain 2021 Jeep Cherokee SUVs were manufactured with transmission oil cooler (TOC) hoses with rubber that had been incorrectly cured. The suspect period began on January 19, 2021 and ended on March 8, 2021, when all suspect TOC hoses were removed from vehicle production.

According to the defect report filed with the NHTSA, incorrectly cured rubber could allow the hose to weaken and rupture. Transmission fluid leaking from the ruptured hose could contact an ignition source and lead to a vehicle fire. A vehicle fire increases the risk of injury to occupants, persons outside the vehicle and could result in property damage.

Owners receiving notices will be asked to return to their dealerships to have the TOC hoses inspected and replaced as necessary. Chrysler’s number for this recall is Y18 and the NHTSA campaign number is 21V-310.

2017 Jeep Patriot
California Lemon Law Buyback

Posted on by

Our client was very happy to buy her 2017 Jeep Patriot.

Her first visit to the authorized dealership was on July 31, 2017. She had multiple concerns that she shared with her service advisor. The tire light was on but all pressures were fine. The passenger front window would not go up with the driver side switch. There was also a problem in that the vehicle would only run for a few minutes when started with the remote.

The next visit was on November 10th because the check engine light was on.

Her last visit was December 6 and her Jeep Patriot was in the shop for 29 days as the check engine light was on again.

She contacted us in January and spoke with Barry L. Edzant, a California Lemon Law Attorney Specialist. He asked her to send our office some documents for him to review. After his review and consultation the client decided she wanted Barry to represent her.

A letter was submitted to FCA, USA demanding they buy back her vehicle under the California Lemon Law. FCA agreed to do so and reimbursed our client her down payment, all payments made, her registration, paid off the vehicle loan minus a mileage deduction the manufacturer is entitled to under the Lemon Law. They also paid the attorney fees. Needless to say our client was thrilled.

If you think your vehicle might be a lemon please give our office a cal and speak with Barry L. Edzant. The toll free phone number is 888-395-3666. Find out your rights under the California Lemon Law.

VW / Jeep – Illuminated Airbag Warning

Posted on by

An illuminated airbag warning light in certain 2019 Jeep Cherokee or 2018 Volkswagen Atlas vehicles could mean an airbag crash sensor needs replacement.

ZF North America, the manufacturer of Remote Accelerometer Sensors (RAS) installed in these vehicles, are recalling certain RAS built from a specific production period. According to the defect report filed with the NHTSA, soldering connections inside the sensors may have been damaged due to exposure to higher than expected temperatures during manufacturing. As reported by FCA and VW, if present in a vehicle, an affected airbag crash sensor may not communicate correctly with the airbag control module. If this occurs, the airbag warning light will illuminate.

Warning: There is a risk of delayed airbag deployment during a frontal crash or a risk of a non-deployment in low speed collisions.

Those receiving notices will be asked to return to their dealers to have the air bag crash sensor replaced. Chrysler’s number for this recall is V63. Volkswagen’s number for this recall is 69AL. The NHTSA campaign number is 20E-052.

Jeep Grand Cherokee / RAM 1500 Engine Stall

Posted on by

Some 2014-2016 Jeep Grand Cherokee and 2014-2018 RAM 1500 vehicles equipped with 3.0L diesel engines may have been manufactured with crankshaft tone wheels that could experience magnetic signal material delamination.

The magnetic material attached to the tone wheel provides a signal to the crankshaft position sensor. If this material delaminates, the engine will lose its ability to synchronize injector pulses and cam timing. Loss of crankshaft position can result in an engine stall and the inability to restart. The problem can occur without prior warning.

The remedy for this condition is not currently available. Dealers will stop the engine from stalling by updating the powertrain control module software to maintain vehicle propulsion by reading the camshaft position signal in the event that the crankshaft position signal is lost. If tone wheel failure occurs, the engine warning light will illuminate but the vehicle will not stall.

The recall to update the powertrain control module software is expected to begin in October. FCA’s number for this recall is W58 and the NHTSA campaign number is 20V-475.

Jeep Cherokee Transmission Wear

Posted on by

Chrysler will be asking owners of certain 2014-2017 Jeep Cherokee SUVs to return to their dealership to repair a problem affecting the two speed power transfer unit (PTU) in their vehicles. The suspect period began in April 2014 when more robust differential input splines were used to manufacture PTUs.

According to the defect report, movement between the differential input splines and the transmission output shaft may result in the input spline teeth wearing. Eventually this will cause a loss of engagement between the transmission and the differential, and torque will not be transferred to the wheels. The vehicle will loose motive power and there will be no “Park” function while the vehicle is stationary.

Dealers will perform a software update that will maintain vehicle propulsion by engaging rear wheel drive and prevent rolling in “Park” by activating the electronic parking brake if a failed input spline occurs. FCA’s number for this recall is W47 and the NHTSA campaign number is 20V-343.

Jeep Grand Cherokee & Dodge Durango Loss Of Power

Posted on by

Chrysler will be contacting the owners of certain 2019 Jeep Grand Cherokee and 2019 Dodge Durango vehicles because of a problem affecting the powertrain of their vehicles.

According to the defect report, the front differential may have been built with pinion gears that were not sufficiently hardened. Over time the gears could wear down until torque power cannot be transferred from the drivetrain to the front wheels. If this happens drivers will experience loss of power and loss of the “Park” function when stationary. Prior to loss of power, drivers may notice a gear whine or grinding noise coming from the drivetrain

Those receiving notices will be asked to return to their dealerships to have the front differential replaced. This recall is expected to begin May 15, 2020. Chrysler’s number for this recall is W22 and the NHTSA campaign number is 20V-183.

Jeep Gladiator & Jeep Wrangler Burnt Clutch Odor

Posted on by

Chrysler will be contacting the owners of certain 2020 Jeep Gladiator and 2018-2020 Jeep Wrangler vehicles, equipped with manual transmissions. These vehicles have a defective power train that could increase the risk of an accident.

According to the defect report, the clutch pressure plate could overheat and break. Fragments from the pressure plate could fracture the transmission case where debris could enter. Debris entering the transmission could result in loss of propulsion or allow heated debris to contact ignition sources, potentially leading to a vehicle fire. In some circumstances, vehicle occupants may notice a burnt clutch odor, or the driver may notice abnormal clutch pedal travel prior to the failure.

A fix for this recall is still under development. Chrysler’s number for this recall is W12 and the NHTSA campaign number is 20V-124.

2020 Jeep Wrangler Steering Vibration & Front End Noise

Posted on by

Chrysler will be notifying the owners of certain 2020 Jeep Wrangler SUVs because of a safety problem affecting the suspension in their vehicles.

According to the defect report, the left side lower control arm bracket may have been out of position during the welding process. This off location weld is weak and could break, allowing the lower control arm to separate from the axle. If this happens, the driver could experience a loss of vehicle control and/or the lower control arm bracket may separate completely, resulting in dangerous road debris. Prior to compete separation of the bracket from the axle, the driver may experience a front end noise or a steering vibration.

Those receiving notices will be asked to return to their dealers to have the front axle inspected and replaced as necessary. Chrysler’s number for this recall is W01 and the NHTSA campaign number is 20V-042.